美能达维修代码（Minable maintenance code）.doc

美能达维修代码（Minable maintenance code） Troubleshooting: mnda copy machine maintenance data (fault code) About the minolda copy machine... The content of the This site searches for more information on the maintenance code of the minolda copy machine EP3170 code The ability to reach 3170 code detection instructions The 3170 code test shows that F1: after paper detection, it can be carried out without preheating, the copier counting device is not working (press clear/stop Stop); F2: charge high voltage output adjustment (factory setting), do not adjust (run for 30 seconds, or according to clear/stop); F3: manually light the lamp voltage setting, press the copy button to start scanning and light the exposure light (for 30 seconds, or press The clear/stop stop) F5: AE sensor base voltage setting, press the copy button to start scanning and light the exposure lamp (for 30 seconds, or clea) R/stop abort); F6: factory setting (end of scan) F8 · ATDC sensor to adjust the imaging device and the developer stirs (running for 5 minutes, or pressing clear/stop) F9: factory setting (running for 30 seconds, or pressing clear/stop) Adjustment mode: 4-1. Adjustment (1) description (adjustment of optical system) A -- 0 to set the focal length of the lens (to determine the change of focal length of the lens) A - 1 adjust the position of the lens and so on (adjust the original and equal distance of the lens) A - 2 adjust the reflector and so on. (adjust the original position of the reflector and the distance between the same position). A -- 3 adjustment of the longitudinal ratio (adjusted by adjusting the scanning speed) A - 4 and so on the position of the paper head (in order to adjust the position of the paper head) A -- 5 enlarging the position of the head position of the image (in the zoom way 200% adjust the image of the paper) 4-2. Adjustment (2) description (adjust the overlap width of black/color reproduction) B - 2 adjust the black/colored overlap (black developer) (adjust the width