组装电视机维修（Assemble the TV maintenance）.docVIP

组装电视机维修（Assemble the TV maintenance） Experience in assembling TV sets 1. The CPU is LC863532A 5z001zr0, and the power grid voltage is too low, please shut down and the power can be read See, no signal, power grid voltage too low, please shut down the words, up and down. Bus LOW AC - IN 63 and HIGH ac-in0, it doesnt work. It occurred to me that the CPU detected the fault of the peripheral circuit. Check and measure C PU11 foot is 4V, normal should be 1.6 V, also can disconnect 11 feet peripheral circuit, measure this foot. The foot The power supply negative pressure capacitance 10UF has no capacity, so it is normal. Occurrence of this fault: bus modulation and maintenance c External circuit of pu voltage detection terminal. 2. High I2C adjustment failure summary 1. Volume 1 is the biggest: STEREO OPT, WOOFER OPT, PWM volume control options are set to 0. 2. The image has a regular flash point: IC SELECT (decoding chip selection) error. 3. No U segment: BAND OPTION (BAND selection) is tuned to 2. 4. No AV switching: the AV OPTION (AV OPTION) is tuned to 2 or 1. 5. Negative image, light grating brighter or darker or even white screen, black screen, tian box: C.B/W (black and white balance set) Set to 0. 6. The image is normal after a minute of jumping up and down: lower the RF. AGC. 7. Black screen and image alternate: the COMB (COMB circuit setting) is adjusted to 0. 8. The POWER grid voltage is too HIGH, please turn off : the POWER HIGH and POWER LOW are adjusted HIGH by excluding hard faults. 9. Open standby program to reverse or press any key shutdown: MOD1 value is not appropriate. 10. Adjustable field, linear invalid (excluding hard failure) : turn MOD0 down. 11. The volume, brightness, color and so on are only in the high middle and low three gears: remote control shutdown restart. The power supply voltage is high: 1. The design of the power standby circuit of the hybrid machine is too simplistic. It is recommended that the power supply should be changed to A966