海德堡故障处理2（Heidelberg fault processing 2）.doc

海德堡故障处理2（Heidelberg fault processing 2） Printed information centre - information centre Heidelberg HD102V four color offset printing press repair An example of the faulty repair of HD102V four-color offset press in Heidelberg (1) Failure 1: the brake device fails and the machine flies after starting Cause: circuit failure; The maladjustment of the brake device (too loose); The copper cushion of the brake device is damaged. Repair: check the braking circuit and troubleshoot; Loosen the brake to adjust the end cover to tighten the screw, and turn the cover clockwise Adjust one Angle and tighten the screw tightly. Carefully disassemble the brake, change the copper pad, if not The product can be used for the use of yellow brass or PS plate with a thickness of 0.3mm thick, and be careful to remove the pieces, so as not to be misaligned or Faulty assembly leads to new failures. Due to the length of space, detailed disassembly, adjustment method from slightly. Failure 2: the host can not run or when good or bad, there is a heating phenomenon, but the transmission device is normal Cause: circuit or commutator main motor failure; Brake device maladjustment (overtight); The brake device is not well maintained and dirty Too much, filling the gap between the chips; If the brakes are too hot for maintenance or other reasons, Inner core steel sheet failure deformation, resistance surge, main engine stop. Repair: check the circuit motor and troubleshoot; Loosen the brake end cover to tighten the screw and rotate counterclockwise to a certain Angle Binding; Disassemble the brake, clean the parts and then assemble it according to the correct procedure; Part or all replacement of steel core Pieces and pieces of copper. Failure 3: when the main engine is operating normally, the point wheel will follow, or when it will stop Cause: the circuit failure, or the limit switch contact gap; 2. The end face of the excitation line and the wheel disk of the point moving device The face assembly