成品油计量（Measurement of refined oil）.docVIP

成品油计量（Measurement of refined oil） Review: 1. Noun interpretation 1, inventory measurement: to determine the regulated oil tank storage quantity, as well as in other measuring equipment of measurement data as pick up based on the business day or batch before and after operation for inventory stock, for the measurement of the oil in the container. 2. Volume correction factor: the ratio of the volume of oil under standard temperature to the volume of its non-standard temperature. Legal unit of measurement: a unit of measurement that is mandatory or permitted by the state in the form of an act. 3, flash point: under prescribed conditions, the heating oil overflow of vapor and air mixture and the lowest temperature will ignite momentarily on application of a flame, use ℃ (c), said is said oil evaporation tendency and safety of the project. 4. Unit of measurement: the unit of measurement is a specific quantity which is used to quantitatively represent the same quantity value, and it has the name, symbol and definition, and its value is 1. 5. Oil products: short for petroleum products, petroleum products in crude oil refining and processing products, including fuel oil, solvent oil and various lubricating grease and related products. 6. Transportation: according to the contract, the contract provides for the transportation loss of the carrier, such as exceeding the provisions, which shall be borne by the carrier for the transport of excess consumption. At present, a lot of water transportation has adopted this mode of transportation. The gas stations of sinopec have been required to adopt this mode of transport. 7, solidifying point: try oil cooled under prescribed conditions, the highest temperature to stop moving when used ℃ (c), said is oil low temperature performance of the project evaluation. 8, dissemination: through the verification or calibration of measuring instruments, the measuring unit of the countrys benchmark repetition by value, through each level measureme