楼梯规范（The stairs specification）.docVIP

楼梯规范（The stairs specification） 4.1.2 the minimum net width of the ladders shall be determined according to the comprehensive factors such as the requirements of use, modulus and fire protection regulations. To illustrate the point that will be six and six layers under the housing ladder section of the minimum width of a 1 m, the reason is: (1) in the past, to meet the provisions of the code for fire protection of stair section of the minimum width of 1.10 m, with 2.70 m or 2.60 m (is not in conformity with the 3) studio stairwells, unit to be a ladder two sets of housing in China, less service units, corresponding stair area may also reduce, if use 2.40 m width and stairwells, each can increase 1 m2 usable floor area, brick house 2.40 m width and stairwells, and stair width can only be 1 m or so; (2.40 m bay is in line with the three modules, and other parameters can be coordinated into a series of 3 mould, not half a module in the plane layout, with 3.60 m can enlarge modulus of parameters, such as series, help reduce artifacts, but also to industrialized production, layout is more applicable and flexible; According to the analysis, 2.40m can be used as long as the width of the staircase can be used to carry the furniture. 2.40m can meet the requirements of use. (4) with reference to domestic and foreign relevant specifications, the former Soviet union shall not less than 1.05 m, Taiwan shall not less than 0.90 m, the coordination with the ministry of public security, the provisions in the code for fire protection design of buildings no more than six layers of unit residence, one side is equipped with emergency staircase railings, the minimum width of not less than 1 m , but all seven and seven layers above unit housing or corridor type, tower houses the minimum width of stairs should be 1.10 m. 4.1.3 the rules and regulations of the stair step width is not less than 0.25 m, height is not more than 0.18 m, its steep slope is 37.75 °, with foreign standards vary wid