山地车 自行车 辐条调节方法（The method of adjusting the bicycle of mountain bike）.docVIP

山地车 自行车 辐条调节方法（The method of adjusting the bicycle of mountain bike） /vod/377771.shtml#flv Bicycle spokes regulation method It is adjusting the spokes of the spokes to adjust the wheel rotation on the same plane. This way, the bike will be more stable. The first thing you need is a spokes wrench, shaped like a circle, with four or six different sizes of bayonets, suitable for different sizes of spokes. At one end of the spokes, there is a 90 degree Angle passing through the hole in the drive, and the spokes on the other end through the spokes of the car. The most common use of spokes is a tri-plait network, which means that each spokes intersect with the other three spokes. There is a rib between the spokes and spokes cap. The spokes cap can be adjusted by spokes. However, the tire must be deflated before adjusting the spokes. Otherwise the spokes cap can easily puncture the inner tube. The adjustment of the spokes is to keep the circle of the car. Here are three ways to observe the cycle: 1. Remove the wheel and install it on the special school rack. 2. Do not remove the wheel, hold the fork in one hand, and lift your thumb close to the inner circle of the car. 3. Observe the gap between the brake and the loop. Either way, the principle is: Turn the wheel, the circle is large between the frame, tighten the spokes here, and the spokes; To the left side of the car, tighten the right spokes, the left spokes. Instead, tighten the left side and loosen the right side. In the end, the entire vehicle is completely evenly spaced out from the frame of reference, and each irradiation is evenly distributed, and the school bus circle is completed. The spokes were initially adjusted Once the ring is completed, all the spokes are adjusted first so that they can spin in as much on the spokes. You can do this with a screwdriver (electric). A good starting point is to turn them all into the spokes of the spokes and just disappear into the spokes nut. If the spokes are somewhat short