压力管道设计审批考试题（Pressure piping design approval test）.docVIP

下载本文档

6
0
约1.14万字
约 11页
2017-08-04 发布于河南
举报
版权申诉

压力管道设计审批考试题（Pressure piping design approval test）.doc

1、本文档共11页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

压力管道设计审批考试题（Pressure piping design approval test） Pressure piping design approval test Work unit: Name: score: 1. Fill in the blanks (1 point each time, 20 points total) 1. The pressure required to convert a gas to a liquid at the critical temperature is called. The gas is called in this state. The parameters in this state are called. (critical pressure, critical state, critical parameters) 2. Mechanical properties of metals refer to the performance of performance, also known as mechanical properties of metals. (the role of external forces) 3. When the saturated vapor is cooled or pressurized, it becomes liquid to the contact surface or condensation nucleus. The temperature under this pressure is called. The temperature at which the vapor pressure of the liquid is equal to the external pressure is called the liquid under the pressure. (dew point, boiling point) 4. The gas pipeline shall be connected directly to the supervisor with a branch, and the opening of the hole shall be strengthened in the area of the opening hole. When the nominal diameter of the branch is less than or equal to mm, it will not be strengthened. When the outer diameter of the branch is greater than or equal, it is advisable to adopt standard three - pass or welding three parts. (50, 1/2 in-charge internal diameter) 5. When the outer diameter or the outer diameter of the protective layer is less than or equal to 50mm of the pipe, it can be used. (mark) 6. The selection of pressure piping materials shall be selected according to the conditions such as the special requirements of the materials, the performance of the material, welding performance and economic rationality. (piping level, design temperature, design pressure) 7. According to different manufacturing methods, steel pipes are divided into two categories. (seamless steel tube and welded steel tube) 8. There are three types of flange gaskets for pressure piping, respectively, and. (non-metallic gaskets, semi-metal gaskets, metal gaskets)