中断函数（The interrupt function）.doc

中断函数（The interrupt function） 1. INTCON interrupt control register zero, |, or 1 Set 0 for output, set 1 for input and input output for a single chip. The understanding of output is that the single chip affects the external circuit and the input is the influence of the external circuit to the single chip. IE: make it possible IF: flag bit GIE: global interrupt, 1 allows all unblocked interrupts, 0 forbids all, PEIE: external interrupt allows for all unblocked external interrupts, and 0 is forbidden T0IE: TIMER0 overflow interrupt allow bit, 1 allows TIMER0 interrupt, 0 forbids break INTE: INT external interrupt allow bit, 1 allows INT external interrupt, 0 is forbidden RBIE: the PORTB level change terminal allows bit, 1 allows the PORTB level change to be interrupted, and 0 is prohibited T0IF: TIMER0 overflow interrupt mark bit, 1 TMR0 register (must be clear), 0 does not overflow INTF: INT external interrupt mark bit, 1 INT interrupts, 0 does not occur RBIF: the PORTB level changes the discontinuity flag bit, and the 1PORTB port has at least one of the pins level state changes, and 0 does not have an INT external interrupt PIE1: external interrupts allow register 1 PIR1: peripheral interrupt request register 1 PCON: power control register A position 1 (= 1) of the TRISB can be used to make the corresponding port b pins as input pins (the corresponding output drive is placed in a high impedance state). The corresponding PORTB pin will be used as the output pin (the content of the outgoing latch is input from the selected pin). 2. STATUS: STATUS register 3. OPTION - REG: OPTION register RBPU: pull on the PORTB to make it possible, 1 bar it from pulling on it, and 0 from the ports various locking values to pull on the PORTB T0CS: TIMER0 clock selection, 1 t0cki pin jump edge, 0 internal instruction cycle clock (FOSC / 4) T0SE: TIMER0 clock edge select bit, 1 at T0CKI signal from high level jump to low voltage, 0 at T0CKI signal from low level jump to high power increm