理光复印机代码表（Light and light copier code table）.doc

理光复印机代码表（Light and light copier code table） SC101 - indicates that the standard white board level was not correctly detected when the flash lamp went wrong and scanned the whiteboard. Possible cause: the lamp is defective; The lamp rectifier is not good; Improper connection of the lamp connector; Standard white board dirty; Mirror or lens dislocation or smudge; SBU is not good. SC102 - indicates that the lights went wrong. After scanning the manuscript, the flash light is on for more than 3 minutes. Reason: SBCU board is not good; Bad performance of IPU board; Poor control board. SC120 - indicates that the scanner is in situ error. During initialization or copying, the scanners in-situ sensor is not detected. Possible cause: scanner motor bad; Motor drive board is not good; Poor sensor in situ sensor of scanner; The wire harness between SBCU and in-situ sensor is loose, broken or damaged. The wire harness between the SBCU and the scanner motor is loose, broken or damaged; SBCU board is not good; Scanner wire, synchronous belt, pulley or scan rack. SC121 - indicates that the scanner is in situ error. Its the opposite of SC120. Probable cause: same as SC120. SC122 - indicates that scanner sensors are wrong. The in-situ sensor is still open when the scanner is returned. Possible reasons: the same. ANAA SC123 - indicates that the scanners in-situ sensor is wrong. The scanners in-situ sensor was not opened after the scanning frame returned to its position. Possible reasons: the same. SC141 - indicates a black color error correction error. Possible cause: the lens block is undesirable; SBCU board is not good. SC143 - indicates that SBU automatically adjusts errors. Possible cause: flash light connection disconnect; No blank A3 paper under the pressure board; The whiteboard is stained or lost. SC144 - indicates that SBU B = plate connection error. Possible reasons: the lines between SBU and IPU are loose, broken or damaged. SC165 - indicates that the replication data secur