汽车地盘实训（Automobile site training）.docVIP

汽车地盘实训（Automobile site training） Practical training program a car clutch disassembly learning I. knowledge requirements 1. Function, composition and principle of the clutch 2. Types, phenomena and causes of common failures of the clutch Main contents: function, composition and principle of clutch; Basic construction of the clutch; The cause of the clutch failure Capacity requirements 1. Proper disassembly and maintenance of the clutch 2. Common fault diagnosis and maintenance of the clutch 2. Practical training 4 class Iii. Actual training equipment 1. Tools: a set of common tools and a vernier caliper. 2. Equipment: clutch assembly one. Iv. Practical training procedures 1. Disassembly and installation of the clutch A. Disassembly of the clutch First remove the transmission. The flywheel is fixed by means of the tool, and then gradually loosen the fixed bolt of the clutch pressure plate, remove the clutch cover and press disc assembly, and remove the clutch driven plate. Then disassemble the clutch components. B. Installation of the clutch Use the tool to fix the flywheel. The clutch driven disc is positioned in the center of the flywheel and the pressure plate. Install the fastening bolts and use 25N. The moment of m is gradually turning against the Angle. 2. Maintenance of the clutch A. Maintenance considerations Pad: replace the paper seal washer and replace the o-ring. Adjust the gasket: check and adjust the gasket with a micrometer, which can accurately measure the thickness of the needed gasket. Check to see if there is any damage to the edge of the gasket and can only be packed in good condition. Retaining ring and locking ring: adjusting the retaining ring and locking ring cannot be pulled apart. It must be completely in the slot. Bolts and nuts: bolts and nuts of fixed cover and cover shall be tightened and unscrewed (especially vulnerable parts) and shall be tightened by the specified tightening torque to tighten bolts and nuts. Bearing: the roller bearing