光缆复习题（Fiber optic cable problem）.docVIP

光缆复习题（Fiber optic cable problem） Review questions 1. Fill in the blanks 1. The cable core structure can be divided into the laminar fiber-optic cable, the center beam tube type optical cable, the skeleton type optical cable and the ribbon type optical cable. 2. The cable can be divided into overhead optical cable, pipeline optical cable, direct buried optical cable, tunnel cable and low-water cable. 3. Optical fiber communication system is composed of optical transmitter, optical fiber optic cable and optical receiver. 4. The optical fiber communication system can be divided into short wave length, long wavelength and long wavelength communication system according to wavelength. 5. Optical fiber wavelength 1525 ~ 1565 nm is called c-band. 6. Optical fiber wavelength 1570 ~ 1604nm is called l-band. 7. The wavelength is shorter than 1525 nm and is called the s-band. 8. The optical fiber of G. 655 is also known as non-zero dispersion displacement single mode fiber. The main contents of the cable construction include: routing and retesting, cable laying, optical cable welding and engineering surveying. The bending radius of the optical cable should not be less than 15 times of the outer diameter of the cable. The construction process should not be less than 20 times. 11. The buried depth of the rock is 300mm in the underground, the deviation is not more than or minus 50%, the deviation is not more than 20%, no weeds are within 300mm around the target stone, and the distance between the stones is not more than 100m. During the construction process, OTDR is used to test and monitor the loss of the contact points. The monitoring methods are: remote monitoring, proximal monitoring and distal loop back - way test. 13. The obstacle of optical fiber optic cable is divided into: general obstacle, complete obstruction, exceeding limit and major obstacle. 14. The principle of the repair of the optical cable line is: first, the trunk line, the forerunners shall be repaired after t