钢筋保护层厚度超标的危害和预防（Harm and prevention of excessive thickness of reinforcing layer）.doc

钢筋保护层厚度超标的危害和预防（Harm and prevention of excessive thickness of reinforcing layer） Harm and prevention of reinforced protective layer thickness exceed the standard. According to GB-50204-2002 concrete structure construction quality acceptance requirements, in the acceptance of concrete sub project shall be carried out before the structure test, one of which is affected by the thickness of reinforcement component protection test. This test is different from the installation of reinforced steel project in the allowable deviation of test group, to reflect the validation check an important indicator of the quality of the project. Structural concrete protective layer thickness inspection requirements In accordance with the relevant requirements, should pay attention to the following aspects. 1, reinforced protective layer thickness error of the test requirement is not greater than 1mm. This requires the use of reinforced protective layer measuring instrument and its accuracy must be not less than this value, and should be tested every engineering to choose the appropriate parts of the local grooving or drilling, to compare the necessary calibration. The 2 component, the protective layer thickness is the main test beams and plates, especially cantilever member. The control points are the main force for steel, bearing capacity and durability of the mobile position will significantly affect the component. 3, test of protective layer thickness of beam, plate steel, to select representative parts, i.e. beam and board member lower middle span is at the maximum bending moment and the upper root end negative moment at the maximum. 4, test of reinforced protective layer of beams and slabs should be inspection and evaluation, comprehensive evaluation can not be mixed together. The acceptance shall be qualified rate of test results should be greater than or equal to 90%. When the first test pass rate of less than 90%, but greater than or equal to 80%, can be drawn again and again the