v-ray 常见问题（Common problems with v-ray）.docVIP

v-ray 常见问题（Common problems with v-ray） Vray common problem solving method Vrays Standard material (VrayMtl) is compared to Maxs Standard material: Vray Standard material (VrayMtl) is specifically Vray renderer used material, so when using Vray renderer when using this material is better than Max Standard material (Standard) on the rendering speed and detail quality is much higher. Second, they have an important distinction, is the Standard material (Standard) Max can make fake highlights (i.e. without reflection phenomenon and only highlights, but this kind of phenomenon in the real world is impossible) and Vray highlights is the strength and reflection. And when using Vray renderer only cooperate with Vray material (Standard material or other Vray material) can produce caustic effect, but in the use of Standard material of Max (Standard) is unable to produce this effect. After the use of the global light in Vray, if there is no control of the interior of the room, there will be a phenomenon of color overflow. What can be done to change the phenomenon of color overflow??? 1: the packaging material of vr can very well control the inner color of the room The specific method is to add a layer of wrapping material to the original material and then reduce the size of the GI 2: reduce the GI modest produce global illumination ` ` can control color good 3: press F10 to reduce the saturated key in indirect lighting, and improve the color benefit. Using Vray rendering, if the parameters are not controlled, the noise will be generated. How to deal with it? The main reason for the noise of the surface is the main relationship between the material selection and the light exposure 1: it is best to choose the material of Vray in choosing the material of the material (instead of choosing Max material) 2: increase the first and second rebounces (the Primary bounces and Secondary bounces) to increase the brightness of the indirect illumination. 3. Increase subdivision value, includi