管线施工程序（Pipeline construction procedure）.doc

管线施工程序（Pipeline construction procedure） The pipe deformation, severe scratches, flange and valve sealing surface damage, the pipe crack does not meet the specifications of materials should be replaced, and make record, do not conform to the standard material should be clearly marked, to prevent the misuse of the next. 3, pipe cutting (1) pipe cutting machine can be adopted and flame welding, cutting, the following 2 can be used for carbon steel pipe cutting machine, not fire welding of stainless steel pipe cutting, cutting machine can be used 2 less than 2 stainless steel tube, stainless steel tube plasma cutting machine or mechanical cutting method, cutting should remove surface oxides and metal slag. Application of galvanized pipe cutting machine. (2) pipe cutting, grinding and cutting considering welding caused by shrinkage, pipe material should be left 1-2mm margin, fixed port should be kept above 100mm margin. (3) after cutting, each cutting material should be marking transplant, marked material, wall thickness and specification. After cutting the unlabeled pipe, without identification, temporarily unable to use. 4, groove machining (1) by mechanical means or by flame welding, cutting groove groove, but must use the angle grinder to grind, remove the oxide slag, groove angle to achieve the requirement of welding, welding groove with inner and outer surface and on both sides of the 25mm to clean up, application of cotton yarn head and wire brush to remove paint, oil, and water splash, stainless steel you must use the stainless steel cleaning brush. (2) after groove processing visual inspection shall not be found there are cracks, slag and other defects, groove cleaning and inspection qualified, welding work should be completed in a timely manner, and make record. 5, group of weld (1) group of pipeline, groove gap and angle meet the standard requirements, the wall thickness of the pipe and pipe fittings for the same group, should make the inner wall of the flush,