玻璃钢杆（The glass steel）.doc

玻璃钢杆（The glass steel） Glass fiber reinforced plastic (FRP) is commonly known as glass fiber reinforced plastics. It is composed of resin matrix and glass fiber reinforced material. It is of high strength and density Small, aging resistance and corrosion resistance and insulation characteristics of good wave penetrating ability, good fatigue resistance and strong in design, has been widely used in aerospace, petrochemical, power electronics, construction, transportation, energy and other aspects. Pultrusion is an important method of manufacturing high performance, high fiber content, low cost of glass steel, not only has the inherent characteristics of pultruded glass steel, and the molding pressure, high temperature, continuous production, its strength, heat resistance and surface quality are greatly improved, the length of can be arbitrarily long. Can replace wood, steel, reinforced concrete and other traditional materials, and its small density, corrosion resistance, insulation and other properties are unmatched by traditional materials. However, limited by the vast majority of domestic glass steel production enterprises affected by the performance of raw materials, molding technology, R D investment and other factors, its products are mainly concentrated in the tent pole, platform grille, cable tray, tool rod function and smaller stress of the product, has not been widely applied in the structure heavy load on. [merit] Light weight: FRP rods density is 1.92g/cm3, about 1/3 of the steel rod (steel sucker rod density is 7.85 g/cm3), can greatly reduce the pumping system load, so you can use small power motors, smaller gearbox, smaller balance blocks, lighter structure. In order to save energy, improve the comprehensive efficiency of the. Good flexibility: the elastic modulus of FRP rods for (4.0-6.0) * 104MPa, only about 1/4 of the steel rod (elastic modulus of steel rod is 2.1 * 105MPa), so you can extend the service life of the sucker rod, can also increase the