电视干扰的检查（Television interference check）.docVIP

电视干扰的检查（Television interference check） The TV screen interference fault focus on examination of parts and maintenance techniques of 2008-11-09 18:02, a fault phenomenon and focus on examination of parts The screen color TV produced by the machine interference fault occurs. Can be roughly divided into three categories: (1) high frequency interference: bright line, bright and bright interference; (2) if interference: all kinds of mesh, and scaly grainy interference; (3) low frequency interference: black, black, black interference. The location and inspection object interference mainly includes: 1. switching power supply to focus on examination of the main power switch contact resistance is too large (normal ohm level); +300V power filter capacitor, switching transformer output voltage filter capacitor whether loss of contact resistance of the contact; internal degaussing is close; a power switch tube (or power thick film block) heat sink ground is good. The parts often produce low frequency interference. 2. high frequency channel key substitution check check on AGC tuner; whether the capacitance loss or open circuit detection (such as the LA768 foot external capacitor C115); high frequency bypass capacitor, snubber circuit has no open notch; image detection in the week, AFT week is in phase shift; each contact is close: the shield ground is good. This part mainly produce high frequency interference. The 3. line scan circuit mainly for oscillation circuit power supply voltage is insufficient; the line drive tube B value is lower (greater than 20), leading to lack of motivation. So as to form a vertical interference and promote the transformation of primary connected RC damping circuit elements whether open or metamorphic (value), line element output pipe, line output transformer well, for example, the output transformer leakage inductance will appear serious dark bars. There are high pressure cap creepage sparking will produce interference spot. High power component so