混合模式详解（Mixed mode detail）.docVIP

混合模式详解（Mixed mode detail） PS layer mode 1, normal mode (Normal mode) - this is the default layer mode, more commonly used. Dont place any mixed layer. When used with the current layer covering the lower the color pixel color. Because the color in PhotoShop as light processing (rather than the physical form, pigment) in Normal mode synthesis or coloring works will not be used subtraction attributes of color. For example, in Normal mode, the 100% choice above 50% opaque red opaque blue choose to produce a light purple, but not when the desired physical pigment mixed up to deep purple. When increasing the opacity of the blue, the color becomes more blue and not too red, until 100% when a combination of opacity blue color. Paintbrush I with 50% opacity to blue painted in red on the same result; in the Red areas on the draw more, have more blue foreground color into the final area. Then, in the Normal mode, has never been one that was more than two color components in the mixed dark darker color mixing. 2, dissolve mode (Dissolve mode) - a random permutation model produces dissolved pixel color from mixed color value associated with pixel opacity. The target layer to form scattered punctate image superimposed on the image bottom layer, does not produce any effect on the color of the image. By adjusting the opacity, can increase or decrease the target layer scatter density. The result is often the picture showing granular or line edge roughness. When the Dissolve mode is defined as mixed mode layer, will have not notice results. Therefore, the best model is the same with Photoshop in the color application tools used together. The U1ssQlve mode in the foreground 100% opaque (or sampling pixels, when used together with the Rubber Stamp tool), the original with the underlying alternating colors to create a similar diffusion dithering effect. Usually used in Dissolve mode color or image samples of the lower the opacity, color or Xiangben spread with the original image pixel f