技术要求大全（Technical requirements）.docVIP

技术要求大全（Technical requirements） technical requirement The 1. part decaling. 2. parts machined surface defects, no scratch, scratch and other damage parts of the surface. 3. remove all burrs. 4. after quenching and tempering, HRC50 ~ 55. The 5. part is 350 to 370 DEG C high frequency quenching, tempering, HRC40 ~ 45. 6. carburizing depth 0.3mm. 7. high temperature aging treatment. 8. the linear size tolerances shall comply with GB/T 1804-M requirements. The 1. part decaling. 2. parts machined surface defects, no scratch, scratch and other damage parts of the surface. 3. remove all burrs. 4. sharp blunt down. 5. enter the assembly of parts and components (including outsourcing and outsourcing), it must have testing departments of the certificate can be assembled. 6. parts before assembly must be cleaned up, there is no burr, flash, scale, rust, oil, chips, colorants and dust etc.. Mainly with the size of 7. before the assembly of parts and components, especially fit the size and the relevant review of interference. 8. in the assembly process of the parts are not allowed to knock, touch, scratch and rust. 9. did not note the stamping shape and position tolerances shall be in accordance with the requirements of GB/T 13916-2002. 10. note stamping tolerances shall comply with the requirements of 13915-1992 GB/T angle. 8.1 did not note the stamping shape and position tolerances shall be in accordance with the requirements of GB/T 13916-2002. 8.2 note stamping tolerances shall comply with the requirements of 13915-1992 GB/T angle. 8.3 auto parts cold stamping processing tolerances limit deviation should be consistent with the requirements of 268-1999 QC/T. 8.4 tolerance does not note by GB/T 15055-2007 stamping tolerances limit deviation) M implementation. 8.5 tolerances limit deviation according to the QC/T 268-1999 automobile cold stamping parts execution. 9. did not note the length size allowable deviation + 0.5mm. 10. casting tolerances are in with the basic configuratio