发光二极管电压范围（Led voltage range）.docVIP

发光二极管电压范围（Led voltage range） In addition to know the color of your G B diode, W WW green, blue, white, warm white R Y red and yellow. In the normal condition. B W WW for the conventional G 3.0-3.5V, R Y 2.5-2.8V. The current general is appropriate (15 Ma Resistance bright LED uses is 400-500 ohm, ordinary by about 1K on the line, but not more than 2K. The light emitting diode reverse breakdown voltage of about 5 volts. The positive volt ampere characteristic curve is very steep, to use the current limiting resistor in series to control the current through the tube. The current limiting resistor R can be calculated using the following equation: R = (EUF / IF) Where E is the power supply voltage UF LED forward voltage drop, IF for general LED working current. The longer the two leads of light emitting diode in a positive, positive power supply should be. Two leads some light-emitting diode as long, but has a convex tongue shell, near the uvula is positive lead. Compared with small incandescent bulbs and neon lamp, light emitting diode characteristics is: working voltage is very low (some only a few volts); the working current is very small (only a few tenths of Ma can be light); and good seismic performance, impact resistance and high reliability, long service life; the current intensity through the modulation can be conveniently modulated by luminescence intensity. Because of these characteristics, the light emitting diode is used as a light source in the photoelectric control device, signal display used in many electronic equipments. Put it into the heart tube strip, with 7 strip light-emitting tubes 7 segment semiconductor digital tube (Figure), each digital tube can display 0 to 90 numbers. The working voltage of the red and yellow light emitting diode is 2 volts, the working voltage of other colors are the working current of the light-emitting diode 3 volt is 20 mA, if connected to the power supply of five V, reducing the working voltage of power supply voltage o