对刀1（Tool setting 1）.docVIP

对刀1（Tool setting 1） (a) GSK980TD mechanical zero function and mechanical zero setting back 1, boot, in manual mode, the cutter from the mechanical zero, back to the mechanical zero; 2, choose the manual method, the tool moves to the security point of exchange tool, manual tool changing No. 1 in the cutter knife; 2, enter the program input interface, input M03, input, S500, input, cycle start, let the spindle rotation; 3, choose the way to No. 1 handwheel, knife in the machining position, the hand wheel moving axis vehicle flat workpiece face, along the X to return; 4, enter the cutter compensation interface, and move the cursor to the 001 page, press Z0, press enter; 5, choose the hand wheel, hand wheel mobile car light axis of the round (to the car can be measured in length), Z (back to back along the knife to facilitate the measurement of the place), press the spindle stop button, and measuring the outer diameter of the D car; 6, enter the cutter compensation interface, and move the cursor to the 001 page, press XD, press enter; 7, select the manual mode, the 1 knife to the safety position, manual tool changing No. 2 knife on the current cutter spindle rotating key is pressed; 8, choose the way of the carriage wheel, 2 light touch workpiece end, along the X to return; 9, enter the cutter compensation interface, and move the cursor to the 002 page, press Z0, press enter; 10, choose again handwheel, carriage No. 2 car of the round to form a small step (car to measurable length), along the Z (back to back the knife for measuring the place), press the spindle stop button, and measuring the outer diameter of the D car; 12, enter the cutter compensation interface, and move the cursor to the 002 page, press Xd, press enter; 13, repeat 7 ~ 12, 3 knife knife, knife knife and so on the other. The threaded tool carriage, a tool tip touch workpiece small steps right angle. Attached program: o0801; T0101; M03 S500; G00 X44. Z2; G71 U2. R0.2 F200; G71 P1 Q2 U0.4 W0.2; N1 G01X11