tvs管（TVs tube）.docVIP

tvs管（TVs tube） Summary TVS tubes are Transient Voltage Suppressors (Transient, Voltage, Suppressor). It is characterized in that the response speed is very fast (NS); anti surge capability with the discharge tube and varistor, the 10/1000 s pulse power is from 400W to 30KW, the pulse peak current from 0.52A to 544A; the breakdown voltage from 6.8V to 550V series, for different voltage circuit use. Characteristic TVS tube with a one-way and two-way one-way points, TVS tube characteristics and zener diode similar characteristics of double TVS tube is equivalent to two of a zener diode reverse series, its main characteristics are as follows: the parameters reverse off state voltage (VRWM voltage) and the reverse leakage current IR: reverse off state voltage (voltage) VRWM said the highest voltage of TVS transistor conduction, the voltage in only a very small reverse leakage current IR. Breakdown voltage VBR:TVS tube through the specified test current IT voltage, this is to indicate the TVS tube conduction mark voltage. The maximum peak current of the 10/1000 S wave allowed by the pulse peak current IPP:TVS is about 5 times the peak current of the 8/20 S wave, and over this current value may cause permanent damage. In the same series, the higher the breakdown voltage, the smaller the peak current allowed to pass through the pipe. The maximum clamping voltage VC:TVS tube flows through the pulse peak current IPP at both ends of the voltage presented. Pulse peak power Pm: pulse peak power Pm is the product of the pulse peak current 10/1000 s IPP and the maximum clamp voltage VC, that is, Pm=IPP*VC. The steady state power P0:TVS tube can also be used to use a zener diode, then the steady state power. The interelectrode capacitance Cj: as with varistors, TVS tube interelectrode capacitance Cj is larger, and the ratio of one-way two-way, the greater the power capacitor is also larger. Transient suppression diode (TransientVoltageSuppressor), referred to as TVS, is a diode typ