CCNA-第5章 安装Cisco设备.pptVIP

Emphasize: Make sure each student has seen a Cat 5 cable. Describe the test for crossover cable determination. If you hold the two ends of an RJ-45 cable side by side, youll see eight colored strips, or pins, at each end. If the order of the colored pins is the same at each end, then the cable is straight through. If the order of the colors is reversed at each end, then the cable is crossed over or rolled. Ethernet uses pins 1, 2, 3, and 6. For crossover, pin 1 is connected to 3, and oin 2 is connected to 6. Crossover cables are used for switch to switch cabling, PC to PC cabling, switch to hub cabling, hub to hub cabling, or router to router cabling. Purpose: This figure describes a simple way to determine whether one should use a crossover or straight thru cable. Purpose: This figure highlights the WAN network. In this section, students will learn how to cable the WAN. Note: The figure illustrates two workgroup WANs. One is an ISDN connection to a home office. The other illustrates a serial Frame Relay or leased line connection to a branch office. Purpose: This figure illustrates the various WAN standards. Emphasize: The serial standards presented in this course, are presented in the figure. For ISDN, use an RJ-45 port. The cable differs from ports used for serial connections. Note that RJ-45 connections will fit into an RJ-48 and vice versa. Tell students not to connect an ISDN cable into anything other than an ISDN port. 　　高级数据链路控制（High-Level Data Link Control或简称HDLC），是一个在同步网上传输 数据、面向比特的数据链路层协议，它是由国际标准化组织(ISO)根据IBM公司的SDLC(Synchronous Data Link Control)协议扩展开发而成的 Purpose: This section describes the various serial standards that support leased line connections. Emphasize: The same 60-pin end that attaches to a Cisco device supports all standards illustrated. Purpose: This section describes the DTE and DCE. Emphasize: The DTE end attached to your router and the DCE end attaches the the CSU/DSU (or modem) which is attached to the service provider’s network