灯座注塑模具设计.doc

灯座注塑模具设计 高分子材料加工工程 学生：杨明 指导老师：王勇 摘要：本课题主要是针对灯座注塑模的模具设计,通过对塑件进行工艺的分析和比较,最终设计出一副注塑模。并从产品结构工艺性，具体模具结构出发，对模具的浇注系统、模具成型部分的结构、顶出系统、冷却系统、注塑机的选择及有关参数的校核都有详细的介绍，同时并简单的编制了模具的加工工艺。通过整个设计过程表明该模具能够达到此塑件所要求的加工工艺，动作可靠，塑件脱模顺利。 关键词：灯座 注塑模具 结构设计  The injection mold of lamp holder design Major：polymer materials processing engineering Undergraduate：Yang Ming Adviser：Wang Yong (College of Polymer Science Engineering,Sichuan University,Chengdu，610065) Abstract：The topic mainly aims at the injection mould of lamp holder design, through to models to carry on the craft the analysis and the comparison, designs a note mold finally. This topic from the product mix technology capability, the concrete mold structure embarks, to molds gating system, the mold formation parts structure, goes against the system, the cooling system, injection molding machines choice and the related parameter examination, has the detailed design, simultaneously and simple establishment molds processing craft. Through the entire design process indicated that this mold can achieve this to model the processing craft which an institute requests The operation of the mould is reliable．The demount of the plastic parts is smooth . Key words：lamp holder injection mould structural design ……………………………………………………………………3 1. 制品的结构及要求………………………………………………………6 2. 制品的工艺性分析……………………………………………………7 2.1 制品的原材料分析……………………………………………………7 2.2 制品的尺寸精度分析…………………………………………………8 2.3 制品的表面质量分析…………………………………………………8 2.4 制品的结构工艺性分析………………………………………………8 3. 确定成型设备的选择与相关工艺参数………………………………8 3.1 制品的体积………………………………………………………………8 3.2 制品的质量………………………………………………………………8 3.3 制品模塑成型工艺参数的确定………………………………………8 4. 注射模的结构设计……………………………………………………9 4.1 分型面的选择……………………………………………………9 4.2 型腔数目的确定及型腔的排列………………………………………10 4.3 浇注系统的设计………………………………………………………11 4.4 型芯、型腔结构的确定…………………………………………………12 4.5 推出方式的选择……………………………………………………12 4.6 侧抽芯机构设计………………………………………………………12 4.7 标准模架的选择…………………………………………………13 4.8 温度调节系统设计……………………………………………………13 5. 注射模设计的尺寸计算………………………………………