AND8147 Achieving Single Stage PFC and Step （AND8147实现单级PFC和步骤）.PDF

AND8147/D An Innovative Approach to Achieving Single Stage PFC and Step-Down Conversion for Distributive Systems APPLICATION NOTE INTRODUCTION Controller Analysis The NCP1651 can operate in either the Continuous or In most modern PFC circuits, to lower the input current Discontinuous mode of operation. The following analysis harmonics and improve the input power factor, designers will help to highlight the advantages of Continuous versus have historically used a boost topology. The boost topology Discontinuous mode of operation. can operate in the Continuous Conduction Mode (CCM), The table below defines a set of conditions from which the Discontinuous Conduction Mode (DCM), or Critical comparison will be made between the two modes of Conduction Mode. operation. Most PFC applications using the boost topology are designed to operate over the universal input AC voltage Table 1. range (85−265 Vac), at 50 or 60 Hz, and provide a regulated Po = 90 W DC bus (typically 400 Vdc). In most applications, the load Vin = 85−265 Vrms (analyzed at 85 Vrms input) can not operate from the high voltage DC bus, so a DC−DC Efficiency = 80%