DISASSEMBLY ASSEMBLY INSTRUCTIONS （拆卸和装配指令）.pdf

DISASSEMBLY ASSEMBLY INSTRUCTIONS MULTISTAGE CENTRIFUGAL PUMPS TMA INTRODUCTION These instructions are for the maintenance personnel for maintenance and/or repair of the indicated pump series. Disassembly and assembly requires expertise and knowledge of the procedures, therefore the work must be carried out by qualified personnel. These instructions must be carefully read and understood in conjunction with the section drawings and tables contained in the manual, prior to attempt any work on the pumps. For safety, installation and maintenance instructions consult the “OPERATING MANUAL FOR CENTRIFUGAL PUMPS” attached to the pump at time of shipment. Consult also any other attached instructions for accessories and/or components included with the pumps such as mechanical seals, heat exchangers, flushing systems, instrumentation, etc. Before operating or working on the pump it is recommended to adopt safety precautions wearing safety attire (hat, glasses, gloves, shoes, etc.) and have ready the necessary tools required for the work to be done. Do not subject the pump or its components to sudden mechanical impacts and /or distortions. Do not damage or scratch the sealing faces. Pay particular attention not to damage flat gaskets and O-Rings. Be careful not to leave foreign matters such as bolts, screws, washers, rags, etc. in the pump. The pump model and serial number appear on the pump nameplate, ALWAYS provide this information when requesting spare parts or technical assistance (see chapter 9). Disassembly and assembly operations require a good understanding of the pump design and the procedures to be followed. Therefore, please familiarise yourself with these instructions and when in doubt do not hesi