IEC60950-1(2005-电气绝缘).pdf

60950-1  IEC:2005 – 177 – 2.8.7.4 Electric strength test Except for reed switches in ELV CIRCUITS, SELV CIRCUITS and TNV- 1 CIRCUITS, an electric strength test as specified in 5.2.2, is applied between the contacts after the tests of 2.8.7.2 and 2.8.7.3. If the contact is in a PRIMARY CIRCUIT, the test voltage is as specified for REINFORCED INSULATION. If the contact is in a circuit other than a PRIMARY CIRCUIT, the test voltage is as specified for BASIC INSULATION in a PRIMARY CIRCUIT. 2.8.8 Mechanical actuators Where the actuating part in a mechanical SAFETY INTERLOCK system is relied upon for safety, precautions shall be taken to ensure that it is not overstressed. If this requirement is not covered by the design of the component, the over-travel beyond the operating position of the actuator shall be limited to 50 % of the maximum, for example, by its mounting or location, or by adjustment. Compliance is checked by inspection and measurement. 2.9 Electrical insulation 2.9.1 Properties of insulating materials The choice and application of insulating materials shall take into account the needs for electrical, thermal and mechanical strength, frequency of the WORKING VOLTAGE and the working environment (temperature, pressure, humidity and pollution). Natural rubber, hygroscopic materials and materials containing asbestos shall not be used as insulation. Driving belts and couplings shall not be relied upon to ensure electrical insulation, unless the belt or coupling is of a special design that removes the risk of inappropriate replacement. Compliance is checked by inspection and, where necessary, by evaluation of the data for the material. Where necessary, if the da