镁合金AZ40M再结晶晶粒尺寸与硬度模型研究-精密成形工程.PDF

摇 摇 摇 摇 摇 摇 精 密 成 形 工 程 第6卷摇 第5期 摇 摇 摇 摇 JOURNAL OF NETSHAPE FORMING ENGINEERING 摇 2014年09月 摇摇摇 76 镁合金AZ40M再结晶晶粒尺寸与硬度模型研究 朱雄,夏华,胡冬,王姝俨 (重庆理工大学 材料科学与工程学院,重庆400054) 摘要: 目的摇 研究变形温度及变形速率对镁合金AZ40M再结晶晶粒尺寸以及硬度的影响。 方法 在gleeble-1500D热模拟机上进行热物理模拟压缩实验,变形温度为250 ~400 益,变形速率为 -1 0.001~1s ,通过金相法观测AZ40M镁合金在不同变形条件下的组织形貌,采用维氏硬度计测出 镁合金热变形后的硬度值。 结果摇 当升高变形温度或降低变形速率时,材料的晶粒尺寸增大且硬 度减小。 结论摇 得出了再结晶晶粒尺寸的变化规律,建立了AZ40M镁合金的晶粒尺寸与硬度的关 系模型。 关键词:AZ40M镁合金;再结晶晶粒尺寸;硬度模型 DOI:10.3969/ j.issn.1674-6457.2014.05.013 中图分类号:TG115.21摇 摇 摇 文献标识码:A摇 摇 摇 摇 文章编号:1674-6457(2014)05-0076-04 Recrystallized Grain Size and Hardness Model of AZ40M Alloy ZHUXiong,XIA Hua,HUDong,WANGShu-yan (College of Materials Science and Engineering,Chongqing University of Technology,Chongqing400054,China) ABSTRACT:Objective To study the effects of experimental temperatures and strain rates on the recrystallized grain size and hardnessoftheAZ40Malloy. MethodsThehotcompressionexperimentswerecarriedoutonthegleeble-1500thermal simulation machine. The experimental temperatures and strain rateswere investigated in the temperature range of 250 and -1 400 益 andthe strainraterangeof0.01and 1s . Metallographicobservationwasusedtoanalyzethemicrostructuremor鄄 phology of AZ40M alloy under different deformation conditions,and the hardness values of magnesium alloy after hot de鄄 formation were measured using Vivtorinox hardness meter. Results The recrystallized grain size increased significantly and thehardness decrease significantly at higher deformation temperature or lower strain rate. Conclusion The variation rule of recrystallized grain