eigrp度量值的.doc

EIGRP基本实验与度量计算R1: Routeren/SPAN Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#line con 0 Router(config-line)#logg sy Router(config-line)#exec-t 0 0 Router(config-line)#exi Router(config)#no ip domain-lo Router(config)#host R1 R1(config)#int s 1 R1(config-if)#ip add 10.10.10.1 255.255.255.0 R1(config-if)#no shutdown R1(config-if)#clo ra 64000 R1(config-if)#exi R1(config)# *Mar 1 00:23:29.347: %LINK-3-UPDOWN: Interface Serial1, changed state to up R1(config)# *Mar 1 00:23:30.351: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1, changed state to up R1(config)# ? R2: ? R2#en R2#conf t Enter configuration commands, one per line. End with CNTL/Z. R2(config)#int s 1 R2(config-if)#ip add 10.10.10.2 255.255.255.0 R2(config-if)#no shutdown R2(config-if)#int s 0 R2(config-if)#ip add 20.20.20.1 255.255.255.0 R2(config-if)#no shutdown R2(config-if)#clo ra 64000 R2(config-if)#exi R2(config)# ? R3: ? R3en R3#conf t Enter configuration commands, one per line. End with CNTL/Z. R3(config)#int s 1 R3(config-if)#ip add 20.20.20.2 255.255.255.0 R3(config-if)#no shutdown R3(config-if)#exi R3(config)# ? 以上的配置已经可以完成由R2分别与R1和R3的通信，测试结果如下： R2#ping 10.10.10.1 ? Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 10.10.10.1, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 32/34/36 ms R2#ping 20.20.20.2 ? Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 20.20.20.2, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 32/34/36 ms R2# ? 回R1启动EIGRP协议。 ? R1(config)#router eigrp ? 1-65535 Autonomous system number ←实则为EIGRP的进程号，也可被用来用自治系统号进行分配。 ? R1(config)#router eigrp 1 R1(config-router)#net 10.10.10.0 ？ ←宣告网络 A.B.C.D EIGRP wild card bits ←EIGRP支持VLSM，可以在这里输入通配符掩码进行精确匹配。 cr ←直接确定 ? R2、R3同时都需要运行EIGRP使R1可以与R3相互交换信息，R2、R3的配置如下： ? R2: ? R2#conf t Enter configuration commands, one per line. End with CNTL/Z. R2(config)#router eigrp 1 R