74LT七号信令介绍.docVIP

74LT七号信令介绍 　　　　广西S1240维护中心 EC74版教程　网址： EC74 L/T N7 Signalling Introduction 1. Specification　　TUP : Technical Specifications of Signalling System No.7 for the National Telephone Network of China (GF001-9001)　　ISUP : 国内N0.7信令方式技术规范综合业务数字网用户部分(ISUP)　　　　　　based on ITU-T Q.763 Codes and Formats　　　　　　　　　　　　　 Q.764 Signalling Procedures　　　　　　　　　　　 　　Q.730-737 Supplementary Service2. General SW Structure　　The signalling is a monoprocess multidevice system. Multidevice means the presence of an incoming and outgoing TACB.　　Both TUP and ISUP are split signallings. A split signalling consists per side (incoming and outgoing) of an ASIG which controls the call and a TSIG which handles on one hand supervisory (block/reset) messages and on the other hand delivers call related messages to the ASIG. The reason for splitting the signalling was a shortage of memory in the TTCE. Now the ASIG resides in the SACE (SCALSV) and the TSIG in the TTCE.　　TUP/ISUP ASIGN FMM FMM_id=0E1CH SCALSVT/SCALSVL/SACEORJ　　NTUP TSIGN FMM FMM_id=0E1EH DNTUPTCE/ENTUPTCE　　ISUP TSIGN FMM FMM_id=0E20H DISUPTCE/EISUPTCE　　Difference with EC72:　　In EC72, TUP and ISUP signalling have different ASIG:　　　　　　 TUP ASIGN FMM FMM_id=0E1DH　　　　　　 ISUP ASIGN FMM FMM_id=0E1CH　　Overview of the physical mapping:　　　　　　　　　　　3．Interface between ASIG and TSIG　　The interface between ASIG and TSIG consists of two compound messages and three non-compound messages:　　Difference with EC72:　　In EC72, the interface is two compound messages:　　17916_LDSH_INTRA_SIG　　17917_INTRA_SIG　　(1)Compound messages　　19130_INTRA_SIG　　19131_LDSH_INTRA_SIG　　The first message is used between TSIG and ASIG when all the references are known. The second is used from TSIG to ASIG when no reference for ASIG is known. (i.e. for supervision messages).　　The VIRTUAL_MESSAGE IDs are an indication for the contents of the virtual messages in the compound message.　　The following table shows which VMs can be included in