Chapter 16 Nuts, bolts, screws and washers （第十六章螺母、螺栓、螺钉和垫圈,）.pdf

Chapter 16 Nuts, bolts, screws and washers ISO metric precision hexagon bolts, screws and nuts are typical washers to suit the above bolts and nuts are covered by BS 3643 and ISO 272. The standard and these are covered by BS 4320. Standard washers includes washer faced hexagon head bolts and full are available in two different thicknesses, in steel or bearing head bolts. In both cases there is a small radius brass, and are normally plain, but may be chamfered. under the bolthead which would not normally be shown Table 16.1 gives dimensions of commonly used bolts, on drawings, due to its size, but is included here for nuts and washers so that these can be used easily on completeness of the text. With an M36 bolt, the radius assembly drawings. For some dimensions maximum Buy this file from /learning-resources.php?promoCode=partnerID=content=storystoryID=1046 is only 1.7 mm. Bolts may be chamfered at 45° at the and minimum values appear in the standards and we end of the shank, or radiused. The rounded end has a have taken an average figure rounded up to the nearest radius of approximately one and one quarter times the 0.5 mm and this will be found satisfactory for normal shank diameter and can also be used if required to drawing purposes. Reference should be made to the draw the rolled thread end. The washer face under the relevant standards quoted for exact dimensions if head is also very thin and for a M36 bolt is only required in design and manufacture. 0.5 mm. Figure 16.1(a) shows the bolt pr