CONNECTIONS IN TIMBER STRUCTURES FIT （连接在木材结构,适合）.pdf

CONNECTIONS IN TIMBER STRUCTURES 6.1 Introduction The competitiveness of a timber structure, relative to other building materials, may be determined by the efficiency of the connections. In most cases the fastening of timber to timber requires little skill or knowledge of design. Consider the widespread use of nails in domestic situations where the handyman routinely uses nails and bolts to construct all manner of timber structures. In heavy construction, joints may require ingenuity and the use of specialized connectors, such as nail-plates, bolts, shear-plates, split rings, coach screws or glued-in threaded rods. The application of these requires some knowledge of design and construction skills. The shrinkage and swelling characteristics of timber in response to drying and wetting, the possibility of fungal decay in the presence of moisture and the need to protect metallic fasteners from fire or corrosion, call for special construction detailing. 6.2 Factors affecting the detailing of connections. Changes in moisture. Changes in the moisture content of the timber will cause the timber to swell and shrink. The dimensional changes in the direction parallel to the grain can be ignored in most cases. The dimensional change in the perpendicular-to- grain direction can be large, especially if the moisture content variation is large. This must be borne in mind when a horizontal timber member is connected to a vertical timber or steel member. If the connectors prevent shrinkage, splitting of the timber may occur. This type of splitting often occurs when treated timber, which generally still has a high moisture content, is bolted to uprights. Figure 1 shows how the timber may split when movement is prevented. The splitting of the timber at the support may reflect negatively on the shear strength of the member. Figure 6.1: Splitting of timb