DDS1C EASTAR PETG Copolyester 6763 Dos （DDS1C EASTAR PETG共聚酯6763 做的）.pdfVIP

PETG copolyester 6763 Do’s and don’ts for extruding fi lm ™ Eastar PETG copolyester 6763 Do’s and don’ts for extruding fi lm Drying Equipment Do Do ™ • Dry Eastar PETG copolyester 6763 at least four hours • Use extruders having L/D ratios of at least 24:1. Outputs at 65°C (150°F) using a desiccant-type dryer. Insuffi cient expected are generally in the range of 2.4 to 4.3 kg/h per drying will cause excessive molecular weight loss during kW (4 to 7 lb/h per horsepower). extrusion, with resultant decrease in physical properties. • Use a low-compression, barrier-type screw. PVC-, • Use a dryer that will deliver air having a dew point polyolefi n-, or styrene-type screws have been used with ™ temperature of –30° to –40°C (–20° to –40°F). Eastar PETG copolyester 6763 with some degree of • Use a handheld dew point indicator to routinely monitor success. For best results, the screw should be designed actual dew point. specifi cally for PETG 6763. • Use a dryer that will deliver air at a velocity of • Use internal screw cooling in the fi rst four feed fl ights of 0.06 m3/min per kg/h (1 cfm per lb/h) of pellets the screw to facilitate feeding and prevent bridging, but being processed. end cooling before Zone 1 on the extruder. • Maintain drying equipment properly. It is critical to check • Use a 24-80-100-80-24-mesh screen pack. The screen regeneration temperatures, supply temperatures, fi lter