Design Of Zpurlinspart2c austroSteel（Zpurlinspart2caustroSteel设计）.pdfVIP

EUROSTEEL 2008, 3-5 September 2008, Graz, Austria DESIGN OF Z-PURLINS: PART 2 Design methods given in Eurocode EN 1993-1-3 Gerald Luza a, Jörgen Robra b a austroSteel, Graz, Austria b Zeman Co, Vienna, Austria INTRODUCTION The scope of part 1-3 of EN 1993 also known as Eurocode 3 is the design of cold-formed members and sheetings. Depending on the complexity of roofs different methods to design Z-purlins are given in this standard. The paper at hand contains an overview of possible methods, the workflow and the effects of the advanced method in detail. Required are the cross section properties for the gross cross section and the effective cross sections as described in part 1. 1 FIELD OF APPLICATION: METHODS The general design concept is given by chapter 6. Special rules for purlins are subject of chapter 10 and Annex E. Purlins can be designed by: • Simplified Method (annex E) • Basic Method (10.1.3 ff) • Advanced Method using 2nd order analysis (10.1.2 (1) +(6) and 10.1.3) • Design by testing according to Annex A. Table 1. Design methods given in EN 1993-1-3 and their limits e e g - t f 2 c c r n o ) s r r n e i I t o o s n i v o s E n f f