ASME B16.10-阀门结构长度.pdfVIP

1992 American Society Of Mechanical Engineers B16.10 Face-to-Face and End-to-End Dimensions of Valves ASME/ANSI B16.10-1992 (REVISION OF ANSI B16.10-1986) Face-to-Face and End-to-End Dimensions of Valves AN AMERICAN NATIONAL STANDARD THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS AN AMERICAN NATIONAL STANDARD Face-to-Face and End-to-End Dimensions of Valves ASME/ANSI B16.10-1992 (REVISION OF ANSI B16.10-1986) THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS 345 East 47th Street, New York, N.Y. 10017 Date of Issuance: January 15, 1993 The 1992 edition of this Standard is being issued with an automatic addenda subscription service. The use of an addenda allows revisions made in response to public review comments or committee actions to be published as necessary; revisions published in addenda will become effective 6 months after the Date of Issuance of the addenda. The next edition of this Standard is scheduled for publication in 1997. ASME issues written replies to inquiries concerning interpretations of technical aspects of this Standard. The [B16.10] Copyright by American Society Of Mechanical Engineers (Mon Aug 13 09:47:24 2001) interpretations will be included with the above addenda service. Interpretations are not part of the addenda to the Standard. ASME is the registered trademark of The American Society of Mechanical Engineers. This code or standard was developed under procedures accredited as meeting the criteria for American National Standards. The Consensus Committee that approved the code or standard was balanced to assure that individuals from competent and concerned interests have had an opportunity to participate. The proposed code or standard was made available for public review and comment which provides an opportunity for additional public input from industry, academia, regulatory agencies, and the public-at-large. ASME does not approve, rate, or endors