屏蔽罩卡座 使用设计参考.pdfVIP

Shield can clip artwork recommend 1. Big size Shield Can which is cover whole PCB had better separate 2 piece can. Distance between shield can pcb layout parallel 0.3mm When you artwork two shield can in parallel, distance consider 0.3mm 0.9mm 0.9mm pcb pcb layout layout 0.3mm 0.3mm 2. When you artwork clip at near memory chip 1) part of sealing resin consider 0.4mm space 2) part of no sealing resin consider 0.15~0.2mm space * Sealing Resin , they call underfill for protecting memory on drop test 3. Position of clip case 1) artwork 4 clip at center is no good when you insert shield can into clip by manual and also weak on drop test No good case 2) artwork 4 clip at edge is good when you insert shield can into clip by manual and also stronger than case 1) on drop test 30 * 17 size Good case 3) artwork 4~6 clip 17 * 15 size Good case 4) artwork 6~10 clip especially in RF part more clip is better effect for EMI shielding 24 * 22 size Good Caution) When you use clip especially in RF part for EMI shielding youd better cut 0.25mm can which is part of clip and can contacted case 5) With screw When you artwork clip at whole pcb you can use clip and screw at the same time 35 *20 size screw hole case 6) For example 7) About can As you can see, you can use efficiently pcb spac