次梁按主梁输入和按次梁输入区别（The secondary beam is different according to the main beam input and the secondary beam input）.docVIP

次梁按主梁输入和按次梁输入区别（The secondary beam is different according to the main beam input and the secondary beam input） Abstract: using PKPM structure design are analyzed in detail, the second beam according to the main girder are losing and the second beam two modeling modes of guide way, structure calculation model of the difference, and the two kinds of modeling method on the internal forces of the periodic structure, component, such as the reinforcement caused by the different influence; According to the two modeling methods, the model is established to compare the results of the two models and verify the correctness of the analysis. A correct modeling approach is provided for structural designers to apply PKPM. Key words: PKPM model secondary beam input main beam input 0 the introduction PKPMCAD software is used for structural calculation when the designer is designing the frame structure. When modeling, the secondary beam has two kinds of modeling input, namely the input of the main beam and the input of the secondary beam. If the secondary beam is modeled with other main beams in PMCAD main menu 1, it is called input beam by the main beam; If the PMCAD main menu 1 is modeled as secondary beam layout, it is called the secondary beam input beam. The two different modeling methods, there are many different in the process, such as guide charge way different, structure calculation model, and so on, at the same time, different ways of modeling, the structure of the cycle and components internal force calculation, reinforcement components to bring different influence. In this paper, we analyze the differences between the two models in detail. 1. Comparison and analysis of the two models When the secondary beam is entered by the main beam, the secondary beam is equivalent to the main beam, which is involved in the overall calculation of the structure with the main beam. The floor load is transmitted directly to the main beam of the same side. Whether or not it is the secondar