制粒技术（Granulating technology）.docVIP

制粒技术（Granulating technology） High speed stirring in our here is generally used as a system with soft wood, and then make the soft material swing to particles, the resulting particles is more hard, high-speed mixing particles, generally does not directly do indeed is the relatively loose some particles and smaller particles, but also in the process of operation, if the right of each parameter control, such as the proper increase of mixing time, can get relatively large particles, and the solid particles Fluidized bed drying, the most suitable for using fluidized bed particle was dry, after the second is the swing of particles, but directly out of high speed stirring particles do not suitable for use of fluidized bed drying, the particles lack a certain hardness, continually churning, collision in the fluidized bed, it is easy to cause the generation of a large number of fine powder As for the difference of the three granulation modes, the particle fluidity is the best, and the second is the high speed mixing grain and the swing grain In terms of the strength of the particles, the maximum is the high speed mixing, the other two are second From the particle size distribution, it should be the most easy to make uniform particles, followed by fluidized bed granules, but if the process parameters are not controlled well, the particles are generally smaller About high speed stirring and swing, I always believe that both should be used, high speed mixing granulator can be made very mixing and the consistence of soft material, if the swing, not only can increase the uniformity of particles, backlog of more because of its role, has considerable strength of granules, more suitable for one step using fluidized bed dry granulating If you just use a high speed mixing grain, you may dry the granules in the oven first, then use the swaying arrangement when the granules are half dry. You may get more uniform particles And step granulating, personally, I think is very promising granu