示波器的使用方法（The use of oscilloscopes）.docVIP

示波器的使用方法（The use of oscilloscopes） The use of oscilloscopes Panel introduction 1. brightness and focus knob The brightness adjusting knob used to adjust brightness of the light (sometimes called oscilloscope brightness), should be used to make proper brightness, if too bright, easy to damage the tube. Focus adjustment knob for adjusting the focus ray (thickness), when used to clear graphics. 2. signal input channel The oscilloscope used for double oscillograph, has two input channels, respectively, channel 1 (CH1) and channel 2 (CH2), which are respectively connected with the oscilloscope probe, then the oscilloscope probe inserted into the ground, measured position measurement. 3. channel select key (vertical mode selection) A common oscilloscope has five channel select keys: (1) CH1: Channel 1 is shown separately; (2) CH2: Channel 2 is shown separately; (3) ALT: alternate display of two channels; (4) CHOP: two channel intermittent display, used for double scanning when scanning speed is slow; (5) ADD: signal superposition of two channels. For maintenance, select channel 1 or channel 2 for more. 4. vertical sensitivity adjustment knob Adjust the vertical deflection sensitivity, should be adjusted according to the amplitude of the input signal of the position of the knob, the knob is numerical instructions (such as 0.5V/div, said vertical direction of each grid amplitude is 0.5V) multiplied by the measured signal number occupied in the vertical direction of a screen, which shows that the measured signal amplitude. 5. vertical movement adjustment knob The measured signal is used to adjust the vertical position of the screen in the light. 6. horizontal scan adjustment knob Adjust the level of speed adjusting knob should be according to the input signal frequency and the knob indication value (such as 0.5ms/div, said the horizontal direction of each grid for 0.5ms), the measured signal multiplied by a periodic lattice share number, namely that the periodic signal can b