联合基础（Joint basis）.docVIP

联合基础（Joint basis） (I) joint basis calculations; The eccentric double column combined foundation calculation program design: double column combined foundation, and is not considered due to the eccentric pillars of the upper load inconsistency occurs. Therefore, the calculated base area is symmetrically arranged. This method of calculation is very close to the two pillars, such as the deformation of the pillars, the calculation of the column foundation, but there is a certain error for the foundation where the two columns are slightly farther away. At this point, it is necessary for the designer to calculate the eccentricity value and enter the value in the base arrangement. Then click the auto generation option again, and the program can recalculate the joint basis according to the eccentricity values the designer entered. The calculation of double beam based on dual axis: directly in the layout of two beams, and then the raft in the beam under local arrangement. (two) calculation of constructional column foundation of brick concrete structure; Brick concrete structures are generally made of strip foundation under the wall, but under the constructional column, they are not independent foundations. Sometimes designers will find that JCCAD software generates an independent foundation under the structural column. This is mainly due to reading the PM constant ten live caused. This will not load combination constructional column concentrated load to the surrounding wall flat. The designer may delete the concentrated load on the constructional column in the load editing, and increase the line load value on the surrounding wall in additional load. Or the designer can directly read the brick masonry load will automatically load, because the load split structure column to the surrounding wall. (three) how to calculate the minimum reinforcement ratio of shallow foundation? The shallow foundation, such as the strip under the wall, and so on, should be taken into account when th