无线座机原理（Wireless landline principle）.docVIP

无线座机原理（Wireless landline principle） Working principle of telephone set 1, feed Power supply. There are two feeding modes: voltage feeding and current feeding. All terminals connected to the switching system are powered by a switch. The general switch supply voltage at 48V, the call feed current between 20 - 50 Ma haoan. Small group telephone and import group telephone supply voltage is about 30V, the feeding current between 20 mA, 60 Ma, which is why one of the reasons why the group telephone program-controlled switches than the transmission distance farther. 2 overvoltage protection Even in the security installation part and external wiring, grounding, lightning in the instantaneous pressure, the residual voltage is above 100V, this is a fatal blow to the switch, the overvoltage protection measures must be taken. Accordingly, there will be over-current and overvoltage protection. 3, ringing Ringing voltage is higher, the domestic general is about 90V. Relays are commonly used to control the flow contact. Ringing is controlled by the switching system, and when a ringing is needed, a control signal is issued that is closed by the relay, and the ringing circuit sends a ringing signal to the user. When the user is off hook, off hook signal monitoring circuit detects by ringing, ringing off immediately. Some of the Group phones are partially powered by high-voltage electronic devices that cancel the relays. 4, status monitoring Through the line on / off state can feedback the following status: user hook and hang up, call state. Telephone dialing and sending code. 5, signal conversion The user circuit is in fact the interface between analog and digital circuits. An analog signal received by the user circuit from the terminal is an analog signal of the electrical signal, so the upper processing system is converted into a digital signal, which is implemented by an encoder. Similarly, after receiving the processing result, the digital signal is converted into an analog sign