框架设计易被忽视的问题和解决措施（Easily neglected problems and solutions of frame design）.docVIP

框架设计易被忽视的问题和解决措施（Easily neglected problems and solutions of frame design） Easily neglected problems and solutions of frame design Summary of recent projects done by myself, there are some experience for your reference. I want to expand this article and write a promotion paper. I wonder if I can You are welcome to make more comments, please note that there are inadequacies! (I) structural problems 1., the trench depth is greater than the base depth, at this time the foundation should be deepened; When a layer of filler wall thickened by ground bearing, trench should deepen or lintel; When the foundation pull beam is located at + 0, the trench should be deepened so as to avoid the beam height. When the 2. layers high, should not use the way of filling wall thickening ground bearing, to prevent cracks caused by the deformation coordination, are advised to set up the fundamental beam, small deformation (when the opening is not in the side, due to the impact, columns and wing wall at this time is actually the wall beam model). When the span is large, the pier can be placed in the middle of the tension beam to solve the deformation. 3. the connection between the infill wall and the main structure is not specified. The concrete can be referred to the 13 chapter of the seismic code (non structural component) or 02SG614 (frame structure filled with small hollow block wall structure). 4. review column minimum stirrup ratio, beam negative reinforcement into the side column, whether more than 0.4LaE on the frame beam torsion awning main reinforcement and stirrup ratio is more than enough 0.28ft/fy. 5. stair board upper reinforcement should lower ribs 0.5 ~ 0.67, and more than 200 people @ Phi 8, up and down the same reinforcement is not reasonable; the landing beam column should not be connected with the upper frame beam, are connected to form a small internal frame, frame beams with complex, small column tension and the column section, amounting to 300, should take the strengt