验车的步骤和提车的注意事项。买车一族必看（The inspection steps and car precautions. Buying a car must see）.doc

验车的步骤和提车的注意事项。买车一族必看（The inspection steps and car precautions. Buying a car must see） 1) confirm the new car * factory date (must be produced within a month) * frame No. * engine No. * product qualification certificate (number and frame number, engine number) * product description * type, power, displacement, seat number, engine model and so on, require manual and physical conformity * total mileage 50km *) tire wear: look, small standard tyres and no small protrusions columnar strip, in order to determine whether the tire not new, but experienced master can still see. * brake disc wear: if the front brake disc has been worn out, the groove print must not be worn (*) warranty warranty must have 4S seal, 4S proved to be formally issued on goods, can be in other maintenance station enjoy the warranty) 2) check power, driving and braking parts * check all kinds of oil: see if there is any oil on the floor, and the chassis has oil stains. Look, under the left, the middle and the right, is the engine cover, is under the oil pan, so that is on both sides of the drive shaft is in the holster, the flywheel side cover lower part, these parts can be seen from every department is narrow, standard of dust phenomenon cannot be wet ground, no oil. Pull dipstick (yellow handle), to check whether the oil level is clear, right. Pull the gearbox dipstick (red handle, automatic SX4), check the transmission oil is clear, whether the appropriate level. * the coolant level of the tank is full and the water pipe is free of leakage *) look at the battery level is appropriate, whether the battery connector corrosion, small green, whether the battery connecting wire is fastened, other places are shaking thread connection. *) look at the tightness of the belt of the generator and compressor) dont blow the gas after the first ignition, and see if the flame will turn off automatically *) start the engine, the tachometer should hit more than 1000 rpm, and then smooth down to about 750 rpm * when