钢筋冷挤压连接（Connecting steel cold extrusion）.docVIP

钢筋冷挤压连接（Connecting steel cold extrusion） Compilation according to concrete structural engineering construction quality acceptance specification GB50204-2002, rebar mechanical joint general technical regulations JGJ107, in the text bold word is compulsory, must be strictly enforced. The cold extrusion connection method of steel bars is a mechanical connection method which is sheathed with two steel bars at the end of the connecting bar, then is extruded by a portable hydraulic press to deform the sleeve, and two steel bars are connected into a whole. This method is suitable for industrial and civil building (structure) building, high-rise building, foundation engineering, etc.. All kinds of reinforced concrete structure with 2040mm II, reinforced joints and different diameter reinforced joints, reinforced ribbed steel bar connection can be connected vertically and horizontally and any inclination angle, the joint strength, stiffness, toughness and uniform base metal. (1) preparation for construction 1. materials (1) ribbed steel bars meet the GB1499 standard for reinforced concrete. (2) the casing material conforms to the GB5310 standard. 2. mechanical equipment The complete sets of equipment for extrusion and extrusion of steel bar are made up of extrusion connection pliers, super high pressure electric oil pump, extra high pressure oil pipe, hanger (manual hoist) and so on. Squeeze connection clamp type YJ-40 extrusion pliers, for diameter of 36~40 ribbed steel butt YJ-32, extrusion type clamp for diameter of 20~32 ribbed bar connection, YJ-23 type extrusion pliers, for diameter of 18~25 ribbed steel butt. 3. operating conditions (1) before pressing, remove the rust, grease, sand, etc. of the steel sleeve and the joint of the steel bar. The end of the steel bar should be straight and bent, and must be straightened if bent. (2) the impurities in the hydraulic system are strictly forbidden. When connecting and dismounting the super high pressure hose, the end should