边界混合（Mixed boundary）.doc

边界混合（Mixed boundary） A mixed user interface Mixed user interface consists of the following items: Feature icon The dialog bar Sliding panel shortcut menu Feature icon To access the mixed tool, click the basic features toolbar, or click insert (Insert) mixed (Boundary Blend). The dialog bar Mixed (Boundary Blend) the dialog bar contains two collector. The two collector pointed out to add, remove or redefine the selected reference chain curve. The two collector with the first direction and two direction curve corresponding to the cross line. Click in the collector, can activate and select the direction of the curve, or use the shortcut menu. Sliding panel Mixed control board, display the following slide panel: The curve (Curves) - create mixed surface selection in the first direction and the second direction of the curve, and to control the order of selection. Select the closed mixed (Closed Blend) check box, the last curve and the first curve are mixed to form a closed ring surface. Closed mixed (Closed Blend) is only applicable to other collectors for one-way empty curve. Details (Details) can open the chain (Chain) dialog box, in order to modify the surface properties and chain set. Constraint (Constraints) - control boundary conditions, including the contact condition of edge alignment. The possible condition for freedom (free), tangent and curvature (tangent) (curvature) and normal (normal). Drag the slider control display (Display drag handles) - display control boundary stretching coefficient drag control slider. Add a side effect curve (Add side curve influence) - enabled side effect curve. In the one-way mixed surface, the designated tangent or curvature (Tangent) (Curvature) Pro/ENGINEER mixed boundary conditions, make the side surface tangent to the reference side. Add internal edge (Add inner edge tangency) tangent - set mixed tangent to the surface of internal unidirectional or bidirectional boundary condition. This condition is only applicable to the su