焊接板式换热器（Welded plate heat exchanger）.docVIP

焊接板式换热器（Welded plate heat exchanger） Welded plate heat exchanger for stress corrosion and protection measures Heat exchanger is a kind of high heat transfer efficiency, small occupied area, convenient installation and use, the quality of heat transfer equipment, light and compact structure and low fouling factor. But due to the limitation of the structure itself, a removable plate heat exchanger using pressure of not more than 2.5MPa, the use of temperature does not exceed 250 degrees, and there is fluid and sealing gasket compatibility of [1]. Therefore, in order to improve the heat exchanger with temperature and pressure, expand the scope of its use, both at home and abroad have developed and manufactured a variety of welding heat exchanger, the welded plate heat exchanger is divided into welded and semi welded type two categories. The two types of welded plate heat exchanger has been increasingly used in chemical, petroleum, power, metallurgy and other fields of heating, cooling, condensation, evaporation and heat recovery process. Welded plate heat exchanger, can withstand the pressure and temperature increased, the sealing performance is good. But because of the medium of the diversity and complexity of the welding process and some unavoidable defects, corrosion still exists. Research and application of corrosion problems, to prevent heat exchanger premature damage caused by corrosion, reduce the waste of resources, reduce unnecessary shutdowns and the resulting economic losses are of great significance. In this paper, only the corrosion and protection of all welded plate heat exchanger are introduced. 1 corrosion corrosion type plate heat exchanger is the main corrosion fingerboard tablets. Although most of the plate is made of stainless steel sheet is pressed and stainless steel has very good corrosion resistance, but in some special conditions, the destruction of the passivation film on stainless steel plate or partial uniform corrosion. Uniform and local co