电脑维修中的焊接技术（Welding technology in computer maintenance）.docVIP

电脑维修中的焊接技术（Welding technology in computer maintenance） Welding technology in computer maintenance Welding technology in computer maintenance A welding, electrolytic capacitor (including small pieces): Get a piece of the motherboard, if this motherboard has damaged the electrolytic capacitor, the first remove it, then replace a good capacitor, roughly as follows: Use a cotton swab stick to the capacitor lead angle coated with a layer of solder paste, and then put the iron on the lead angle, tin. The use of tin iron on heat transfer, the two corners of the hot tin lead, so you can take it off. After take off a hole inside the capacitor, there is some tin, so a good capacitor is not put up, then, we use the iron tin hole burning, with the tin solder sucker suction. Then, the positive and negative pole and the capacitance change after the standard type alignment on the motherboard installed, then add solder on the back of the hole, so that the electrolytic capacitor is welded. The replacement of small crystal, jumper pin are available to the above method. Two, PCB board break repair Break the PCB board, mostly in two cases: Thick line 1, the motherboard, thick lines are the power lines, power transmission line is line voltage, current abruptly, likely to put the line broken. 2, some thin edge of the motherboard, the motherboard and sometimes we may rub, put this thread to touch is broken. We got a piece of board, if the judgment is already damaged the line, must use knife to break the surface of the insulating layer, the copper exposed to chaos, in the copper coated with solder paste, soldering iron and copper in tin, because the metal is tin can (stainless steel stick) so a copper wire plus the tin surface will become white, looking for a thin copper wire with the same method, the copper wire and solder. Then the copper wire disconnection and corresponding on the motherboard, with iron heating so that you can break repair, can be coated with a layer of insulating paint