2012-2013年项目负责人安全生产网络教育试题（2012-2013 years project leader safety production network education examination questions）.docVIP

2012-2013年项目负责人安全生产网络教育试题（2012-2013 years project leader safety production network education examination questions） 2012-2013 years project leader safety production network education examination questions 2012-2013 years project leader safety production network education examination questions Tip: length of examination (50 minutes) remaining time (0 hours, 49 minutes, 17 seconds): please do not close the window and refresh the page during the exam! (the system automatically saves the answer every 10 minutes) Radio question (30), 1 points for each question, 30 points (1) According to the provisions of the Regulations of the industrial injury insurance, from January 1, 2011 onwards, the death of production safety accidents caused by workers, the one-time grants workers killed for the adjustment of the standard according to the national annual per capita disposable income of urban residents ( ) double calculation, issued to workers, workers, close relatives. A:10 B:200 C:30 D:40 (2) when the peoples governments at or above the county level perform their duties of safety supervision and inspection, they can not guarantee the safety of the major hidden dangers of accidents found before or during the process of removal, and the necessary measures taken are ). A: continue construction, B: change construction team C: ordered the evacuation of personnel from dangerous areas or temporary construction, and D: ordered the construction units to be examined by the principal person in charge (3) in accordance with the regulations on the administration of safety production in construction projects, the State implements () the system, equipment and materials that seriously endanger the safety of construction. A: limits the use of B: for periodic cancellation C: eliminated D: and banned production (4) when the steel cutting machine cuts the material, the distance between the hand and the cutter should be more than 150mm. If the holding end is less than (), the bushing or clamp shall