loadboard及测试板pcb设计参考（及测试板PCB设计参考负载板）.docVIP

loadboard及测试板pcb设计参考（及测试板PCB设计参考负载板） Considerations on material selection and wiring considerations of hybrid circuits PCB Q: in todays wireless communication equipment, radio frequency part is often used in outdoor unit of miniature structure, and the RF part, if part of the outdoor unit, and the low frequency circuit part for the monitoring of the outdoor unit is often deployed on the same PCB. Whats the material requirement for this PCB wiring, please? How to prevent interference between radio frequency, intermediate frequency and low frequency circuits? Answer: mixed circuit design is a big problem, it is difficult to have a perfect solution. General RF circuits in the system as an independent single board layout, wiring, and even there will be a special shielding cavity. Moreover, the RF circuit is usually single-sided or double sided, and the circuit is simple, all of which is to reduce the influence of the distribution parameters of the RF circuit, and to improve the consistency of the RF system. Compared with the general FR4 material, the RF circuit board tends to adopt the substrate with high Q value, the dielectric constant of this material is relatively small, the transmission line has smaller capacitance, higher impedance and smaller signal transmission delay. In the design of hybrid circuits, although radio frequency and digital circuits are on the same block of PCB, they are usually divided into the RF circuit area and the digital circuit area, respectively. It is shielded by earthing, through hole and shielding box. Methods and rules for input and output termination Q: in modern high-speed PCB design, the input or output terminals of the device are often terminated in order to ensure the integrity of the signal. What are the modes of termination? What are the factors that determine the mode of termination? What are the rules? Answer: termination (terminal), also known as matching. In general, according to the matching location, the active terminal mat