pcb的经验总结（Experience in PCB）.docVIP

pcb的经验总结（Experience in PCB） PCBs experience summary 2009-03-10 23:341. On the PCB board, mark clearly: VCC GND to write next to the polarity of the capacitor, the magnitude of the output voltage, and others. Two Crystal circuit as close to the chip as possible, but not too much near the line. Some people say crystal circuit to be pure: In the system stability, the PCB crystal circuit processing is also very important, the crystal oscillator decentralization does not go the line, the crystal oscillator circuit must be as close as possible to the chip, The shell of the crystal oscillator should be grounded and enhance the ability of resisting electromagnetic interference. Bold CLK lead Clock and other devices, as far as possible not to the edge of the board Three Magnetic beads can be used to connect digital, analog power, digital analog, and so on. Magnetic beads are used to suppress high frequency noise and spike interference on signal lines, power lines, and to absorb electrostatic pulses. Four When youre painting the component library or the PCB library, put a pad on it, When you put it, change the coordinates to 0, 0 Again, you can quickly find coordinates 0, 0 5. some uses of Protel: PCB: In Design Rules, various rules can be set up, such as line width and line distance (the general process is not more than 8mil) In Design, Rules-Manufacturing-Polygon, Connect, Style, you can do copper cross connection settings. Select tools/preferences/display--Transparent Layer (transparent display) In this way, the component layer and the wiring layer are translucent, so that the wiring of the components can be seen clearly Try to select tools/preferences/Options--Other--Cursor Type as Large 90 Thus, the cursor can be visually used as a cross ruler SCH: In Tool-Annotate, the device is automatically numbered. In Global, it can be globally modified, encapsulated, and so on, by matching PART, FOOTPRINT, X, Y, SELECTION, etc. Frequently used shortcut keys, see another Six The rol