pe管径选择（PE diameter）.doc

pe管径选择（PE diameter） PE pipeline has the characteristics of easy construction, fast speed, corrosion resistance, no pollution and long service life. There are two main ways of PE pipe connection: hot melt connection and electrofusion connection. PE pipe diameter is greater than 90MM by hot melt can be fused, different grades, grades of polyethylene materials for the manufacture of pipe fittings or equal to the outer diameter of different diameter pipe fittings must be used welding connection. Outer diameter of less than or equal to 63MM, and other materials, pipes, valves and accessories connections, the use of plastic steel transition joint connection, greater than 63MM flange connection. When the bending radius is greater than or equal to 25 times the outer diameter of the pipe, it can be bent with natural flexibility. Hot melt connection principle is with the two PE pipeline surface heating up close to its smooth surface until the melt in the heating tool, remove the heating tool, will face close to two melt together, to maintain joint cooling under pressure to form a whole. Connecting steps to the welding machine: Welding preparation. The preparatory work for hot melt welding is as follows: Slip the slip with the specification of the pipe into the rack; Prepare sufficient support to ensure that the pipe to be welded can be at the same height as the center line of the frame and be easy to move; Set the heating temperature 200 ~ 230 degrees (the data in Hangzhou Machinery Factory supply water machine for reference, the specific temperature to the data provided by the manufacturer.); Switch on the power supply of the welding machine, turn on heating plate, milling cutter and oil pump switch, and test operation. Two, welding. The welding process is as follows: check and clean the pipe, pipe, tube end fastening milling pipe end, check the pipe end clearance, dislocation and heating pipes and observe the minimum edge height, pipe welding and cooling to the required tim